Jabra T5330 User Manual - Page 5

English 3. Setting up your desk phone 3.1 3.2 3.3 If your telephone has a headset port, go directly to 3.2b. 3.1 Unplug handset cord from your telephone and connect to the port on base unit marked with . 3.2a Connect enclosed telephone cord to the now empty handset port on telephone, and to the port on base unit marked with . 3.2b (Headset port use only) Connect enclosed telephone cord to the headset port on telephone, and to the port on base unit marked with . 3.3 Connect AC power adapter to port on bottom of base unit, then connect to AC power outlet. Visual indicator on base will light green. 3.4 3.5 2 sec 3.6 3.7 3.8 3.9 Note: AUX port is used for Remote Handset Lifter (RHL). Please refer to Appendix. 4 3.4 Place headset in charge cradle and charge a minimum of 30 min. before use. A full charge takes about 2 hours. Visual indicator on headset will flash green while headset is charging, and light steady green when fully charged. 3.5 Turn on headset by pressing answer/end button for 2 sec. (visual indicator will flash twice with green light and will beep three times), or by placing headset in charge cradle. Turn off headset by pressing answer/end button for 2 sec. (visual indicator will flash twice with green light and will beep three times). Clear dial tone 3.6 Take headset out of charge cradle and put it on. 3.7 Lift handset from telephone, tap the Answer/End button on the headset to establish an audio connection and listen for a dial tone in headset. 3.8 If dial tone is missing or unclear, slowly slide the clear dial tone switch on bottom of base unit through the 3 settings. 3.9 Set switch to the position that gives the clearest dial tone. 5 English