Jenn-Air JUGFL242HL1 Owners Manual 1 - Page 9

CUSTOM OVERLAY PANEL INSTALLATION IMPORTANT:  Create custom overlay panel according to the specifications in the "Custom Overlay Panel" section.  JennAir is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. 1. Open the door completely to 90°. 3. Using two people, hold the custom overlay panel against the door. Be sure that the top and bottom hinges fit accurately into the routing on back of the custom wood panel. 90° NOTE: Handle needs to be installed before the custom overlay door panel has been installed on the refrigerator door. 4. Fasten the custom panel to the door using two wood screws (provided in installation kit) at each corner. A 2. Remove the gasket from the corners of the door, pulling gently until the two screw holes in each corner of the door can be seen. NOTE: The gasket does not have to be removed from the door, only the corners. A A B A. Screw holes B. Gasket A A. M4 x 30 flathead screws (provided in installation kit) 5. Press the gasket firmly back into it's original position. 9