Jensen HD5212 Operation Manual - Page 10
Removing the Radio, Connecting the Satellite Radio Receiver, optional, Technical Assistance - wiring diagram
UPC - 043258304117
View all Jensen HD5212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Removing the Radio To remove the radio after installation, remove the trim ring by pulling outward on one side and then the other. Insert the removal keys straight back, with the notches facing up, until they lock. With the removal keys engaged, pull the radio straight out. If removal keys are inserted at an angle, they will not lock properly to release the unit. REMOVAL KEYS Connecting the Satellite Radio Receiver (optional) Before you can listen to satellite radio, you must install the satellite receiver and antenna (purchased separately). The satellite radio receiver is the central data receiving equipment required to process the satellite signals from the external antenna. It is typically installed in the dash, under the seat, or in the trunk or rear of the vehicle. Do not mount receiver near a heater vent or where it can be exposed to extreme temperatures. In addition, when running the wire for the external antenna do not kink or pinch the antenna cable. A sharp 90 degree bend or slight "nick" to the outer cable sheath will cause signal degradation. The wiring diagram will help you identify the proper connections. Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday. 6 HD5212