Jensen HD5212 Operation Manual - Page 9

HD5212 9. Attach one end of the perforated support strap (supplied) to the screw stud on the rear of the chassis using the hex nut provided. Fasten the ISO INSTALLATION other end of the perforated strap to a secure part of the dashboard either above or below the radio using the tapping screw and washer provided. Bend the strap, as necessary, to position it. CAUTION: The 4 5 rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration. The strap also ensures proper electrical grounding of the unit. 10. Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit. TUNE/CH ENTER BAND SEL IPOD MUTE MONO HD5212 EQ PRA0~E~9ZSS DISP 1 AUX IN 2 SCN 3 RPT 4 SHF PS FILE/FOLDER SRC CAT/DIR 5 6 SAT READY 2 3 NOTE: For proper operation of the CD player, the chassis must be mounted within 20° of horizontal. Make sure the unit is mounted within 6 this limitation. ISO Installation This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to mount the radio to the dashboard. Please consult with your local car stereo shop for assistance on this type of installation. 1. Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used to mount the new radio. 2. Carefully unsnap the plastic frame from the front of the new radio chassis. Remove and discard the frame. 3. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio using the same screws. Do not exceed M5 x 9 MM maximum screw size. Longer screws may damage components inside the chassis. 4. Wire the new radio to the vehicle as outlined in the Universal Installation instructions. 5. Slide radio chassis into dash opening and secure with factory radio screws. 6. Reinstall dash panel Kit Installation If your vehicle requires the use of an installation kit to mount this radio, follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit. 1. Wire and test the radio as outlined in the Universal Installation instruc- tions. 2. Install the radio/mounting plate assembly to the sub-dashboard according to the instructions in the installation kit. 3. Attach the support strap to the radio and dashboard as described in the Universal Installation instructions. 4. Replace the dashboard trim panel. Fuses When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The HD5212 uses one 15 amp fuse located below the wiring connector (15 amp fast blow ATO). Reconnecting the Battery When wiring is complete, reconnect the battery negative terminal. 5