Jensen HD5212 Operation Manual - Page 22

HD5212 FIle Playing Order When selected for play, files and folders (Folder Search, File Search or Folder Select) are accessed in the order they were written by the CD writer. As a result, the order in which they are expected to be played may not match the order in which they are actually played. You may be able to set the order in which MP3/WMA are to be played by writing them onto a medium such as a CD-R with their file names beginning with play sequence numbers such as "01" to "99". For example, a medium with the following folder/file hierarchy is subject to Folder Search, File Search or Folder Select as shown below. Installing a USB Device Gently lift the rubber USB slot cover (22) from the top and pull it down. Insert your USB thumb drive into the USB slot on the front of the radio. The unit will automatically search for MP3 and WMA files on the device and begin playback. You can access USB PLAY mode from any other mode by pressing the SRC button (2). "USb" is displayed in the bottom left corner of the LCD. NOTE: Not all USB devices are supported by this unit. Standard USB memory sticks approved by Microsoft are supported. WARNING: Do not remove the device when USB PLAY mode is active. Press SRC (2) to change to another mode before removing the device. 9 1 4 5 6 8 19 20 7 21 2 10 11 TUNE/CH ENTER BAND SEL IPOD MUTE MONO EQ HD5212 A~Z PRESS 0~9 DISP PS FILE/FOLDER SRC AUX IN CAT/DIR 1 2 SCN 3 RPT 4 SHF 5 6 SAT READY 3 13 12 14 15 16 17 18 22 Loading an MP3/WMA Disc Press the open button (9) to lower the front panel, then Insert an MP3/WMA disc. After the disc is loaded, the track number and elapsed time will appear, then the display will scroll through any ID3 Tag information while the file is playing. If the disk contains ID3 tag information, you can scroll through it by pressing the DISP button (7). If no ID3 tag information is available, the unit will display the elapsed time. When ID3 information is available, the display will alternate between track name and format/track number. Loading an SD Card Insert the SD card, label side up, into the SD slot located behind the front panel. Replace the front panel when finished. NOTE: You must remove the front panel to access the SD card slot. See "Detaching the Front Panel" on page 7. The unit will read the files on the card automatically. "Sd" appears in the bottom left corner of the display when an SD card is being read. To remove the card, first press the SRC button (2) to switch to another mode and stop SD playback. Press in on the card to eject it, and then pull it straight out. Most cards have a thin recess that helps with removal. 18