Jensen HD5212 Operation Manual - Page 29

Troubleshooting

Page 29 highlights

HD5212 Troubleshooting Problem Does not operate (display does not light) No power to unit No speakers operate (display lights normally) Not all speakers operate Blows fuses CD skips too much ERROR 1 No File Disc error Cause Corrective Action No power to yellow wire; Check connection with test light; no power to red wire check vehicle fuse with test light Fuse blown Replace fuse Front panel not installed Reinstall front panel properly Fuse blown Check/replace fuse Speaker harness not con- Connect speaker harness; check nected speaker wires Incorrect splices or con- Check all splices and connec- nections tions Speaker wires shorting to Check splices, insulate all bare chassis ground or to each wires other Power wire shorting to ground Make sure wire is not pinched Speaker wires shorting to Make sure wire is not pinched ground Incorrect fuse/fuse too small Install fuse of correct rating Receiver mount is not Check mounting and backstrap, solid or backstrap is not tighten if needed secure Installation angle more Adjust angle to less than 30% than 30% Mechanism error Press reset button No supported files found Insert different disc card with on disc/card appropriate file type Disc dirty, scratched, upside down Replace with clean, properly installed disc 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

25
HD5212
Troubleshooting
Problem
Cause
Corrective Action
Does not operate
(display does not
light)
No power to yellow wire;
no power to red wire
Check connection with test light;
check vehicle fuse with test light
Fuse blown
Replace fuse
Front panel not installed
properly
Reinstall front panel
No power to unit
Fuse blown
Check/replace fuse
No speakers oper-
ate (display lights
normally)
Speaker harness not con-
nected
Connect speaker harness; check
speaker wires
Not all speakers
operate
Incorrect splices or con-
nections
Check all splices and connec-
tions
Speaker wires shorting to
chassis ground or to each
other
Check splices, insulate all bare
wires
Blows fuses
Power wire shorting to
ground
Make sure wire is not pinched
Speaker wires shorting to
ground
Make sure wire is not pinched
Incorrect fuse/fuse too
small
Install fuse of correct rating
CD skips too much
Receiver mount is not
solid or backstrap is not
secure
Check mounting and backstrap,
tighten if needed
Installation angle more
than 30%
Adjust angle to less than 30%
ERROR 1
Mechanism error
Press reset button
No File
No supported files found
on disc/card
Insert different disc card with
appropriate file type
Disc error
Disc dirty, scratched,
upside down
Replace with clean, properly
installed disc