Jensen JGW8130DDB Use and Care Guide - Page 6
Ovenco
UPC - 719881125190
View all Jensen JGW8130DDB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
OVENCo K=N To set the Clock: 1. Press the Clock pad. ( Clock • The time of day flashes in the display. 2. Press the appropriate number pads to set the time of day. • Colon flashes in the display. 3. Press the Clock pad again or wait four seconds. • The colon will remain on. When electrical power is supplied or after a power interruption,the last clock time before power was interrupted will flash. To recall the time of day when another time function is showing, press the Clock pad. 3. Press Timer pad again or wait four seconds. • The colon stops flashing and the time begins counting down. • The last minute of the timer countdown will be displayed in seconds. 4. At the end of the set time, one long beep will sound and "End" will be displayed. 5. Press the Timer pad to clear the display. To cancel the Timer: TIMER ,: 1. Press and hold the Timer pad for three seconds OR 0 /: 2. Press the Timer pad and press '0' using the number pads. Clock time cannot be changed when the oven has been programmed for Delay Cook, Delay Clean or Cook & Hold. To cancel the Clock display: If you do not want the time of day to display: Locking the Control and Oven Door Tile touchpad and oven door can be locked for safety, cleaning, or to prevent unwanted use. The touchpads will not three seconds. The time of day will disappear Pfroremssthaenddihsopldayth..e....C...A..N...C..E...L.. and Clock pads for _[&NcE \,L function when locked. When the clock display is canceled, press the Clock pad to briefly display the time of day. ( Clock ) If the oven is currently in use, the touchpads and door cannot b. e locked. When the clock display is canceled, after 15 minutes, the oven control will go into Standby Mode to save energy. The display will be blank and the oven light will not operate. To "wake up" The current time of day will remain in the display when the touchpads and door are locked. To lock: the control from Standby Mode, press any touchpad. A double beep will sound. To restore the Clock display: Press and hold tile CANCEL and Clock pads for three seconds. The time of day will reappear in the display. 1. Press and hold the CANCEL and Oook & Hold padsfor three seconds. • OFF appears in the display • LOCK flashes while the door is locking. To unlock: _CANCEL, I_ _-_,- _- '\ Ho!d,, / Timer Press and hold the CANCEL and Cook & Hold pads for three seconds. OFF disappears from the display. The timer can be set from one minute [00:01] up to 99 hours and 59 minutes [99:59]. The timer can be used independently of any other oven activity. It can also be set while another oven function is operating. The timer does not control the oven. It only controls a beeper. To set the Timer: 1. Press the Timer pad. • 00:00 and TIMER flash in the display. TIMER 2. Press the appropriate number pads until the correct time appears in the display. ° The colon and TIMER will continue to flash. J 1 Nthoeteo:veTnhetetmoupcehraptaudrse aisn4d0o0v°eFnodroaobrocvaen.not be locked if | Fault Codes BAKE or LOCK may flash rapidly in the display to alert you if there is an error or a problem. If BAKE or LOCK flash in the display, press the CANCEL pad. If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a few minutes, and then reconnect power. If the flashing still continues, disconnect power to the appliance and call an authorized servicer. 5