Jensen UMP9020 Owners Manual - Page 8

OPERATING INSTRUCTIONS 13 - 18 Station Pre-Set Memories To set any one of the 6 pre-set memories (1318) in each band, use the following procedure: 1. Turn the radio on and select a band. 2. Select the first station to be pre-set using the MANU/SKIP buttons (6). 3. Press and hold the pre-set button (13-18) to be set for approximately 2 seconds. The pre-set number appears on the display panel. The station is now stored and can be recalled at any time by pressing that button. 4. Repeat the above procedure for the remaining 5 pre-sets. Six stations can be stored for each band. 20 Display Selector (DSP) This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the radio frequency or CD player track indication is displayed, but the unit will display the time when the DSP button (20) is pressed. The time will display for approximately 5 seconds then return to the radio or CD player function display. Setting the Clock To set the clock, perform the following steps: 1. Turn the vehicle ignition and radio on. 2. Press the DSP button (20) to display the clock. 3. Press and hold the DSP button (20) until the time flashes. 4. Press the Down Tuning ( ) button (6) to adjust the hours and the AM/PM indication or the Up Tuning ( ) button to adjust the minutes. The adjusted time will remain on the LCD display for 5 seconds, or until the DSP button is pressed again. AM/FM/CD/MP3/WMACASSETTE RECEIVER ULTRASERIES UMP9020 7 TAPE OPEN CLOSE CD OPEN CLOSE EJ MUTE 20 0 SCAN AMS D-AUD PAU 3 in 1 CD/MP3 CASSETTE RECEIVER SCN RPT SHF CD- / CD+ 13 14 15 16 17 18 WMA BAND LOUD 9 MANU SKIP 8 8 UMP9020 6