Kenmore 4045 Use and Care Guide - Page 18
Adjusting, Oven Temperature - review
View all Kenmore 4045 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Adjusting the Oven Temperature Your new oven has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you feel your oven is too hot or too cool from your baking experience, the oven temperature may be adjusted to your liking, see instructions below. Note: DO NOT adjust your oven temperature based on oven thermometers, such as those found in grocery stores because they may not be accurate. To Adjust Oven Temperature: 1 Press _ 2. Set the temperature to 550°F (287°C) by pressing and holding the j_. 3. Within 2 seconds, press and hold until the 2 digit display appears. Release _. The display now indicates the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0." 4. Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°C)_in5°Fstepsbypressingandh_ldingthe A or V. Adjust until the desired amount of offset appears in the display• When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees• 5. When you have made the desired adjustment, press :_:: to go back to the time of day display• Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature. Before You Call Solutions to Common Problems Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance• OCCURRENCE Oven Control Beeps and Displays any F code error (example F11). =dr=is displayed. Installation. Entire oven does not operate. POSSIBLE CAUSE/SOLUTION Electronic control has detected a fault condition. Press STOP/CLEAR to clear the display and stop the beeping. Reprogram the oven. If a fault reoccurs, record the fault number• Press STOP/CLEAR and call Sears or another qualified servicer• The door was left open and controls set for self-cleaning cycle. Close the door and push CANCEL pad. Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level• Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and level• Contact cabinet maker to correct problem• When the oven is first plugged in, or when the power supply to the oven has been interrupted, the display will flash• The oven cannot be programmed until the clock is set. Be sure electrical cord is securely connected into the electrical junction box. Cord/plug is not installed and/or connected• Cord is not supplied with oven. Contact Sears or another qualified servicer• Service wiring not complete• Contact Sears or another qualified servicer• Power outage• Check house lights to be sure. Call your local electric company• Short in cord/plug. Replace cord/plug. Controls are not set properly• See instructions under Setting Oven Controls to set the controls• 18