Kenmore 4804 Use and Care Guide - Page 27

Self-Cleaning Self-Clean Cycle Time Length The FLEX CLEAN @ pad controls the Self-Cleaning feature. When used with a the Delay Start @ pad, a delayed Self-Cteaning cycle may also be programmed. The Flex Clean feature allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00). You may also choose the clean time in 1 minute increments (for example 2 hours and 50 minutes) by pressing the number keypads OC>db If you are planning to use the oven directly after a self-clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours to complete. *It is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for average soils, and a 4 hour cycle for heavy soils (to assure satisfactory results). INSTRUCTIONS PRESS To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape. DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the SelfCleaning cycle has completed. The oven may still be VERY HOT. DISPLAY To start an immediate Self-Cleaning cycle or to set a Delay Start time of 9:00 o'clock and shut-off automatically (example provided is a default 3 hour Self-Clean cycle) 1. Be sure the clock is set with the correct time of day, the oven is EMPTY and the oven door is closed. 2. Press _-_. "CLEAN" will flash and "3:00" HR will show in the @ display (Fig. 1). The control will automatically clean for a 3 hour period (default self-cleaning cycle time). Note: if a 2 or 4 hour Fig. 1 i!_!i!iC_!iiiii clean time is desired, press (_ @ (_) for 2 hour or press (_) (_ @ for a 4 hour clean time. Set the cleaning time based on the amount of soil: light, medium or heavy (* See above). Fig. 2 3. Press _A_. The "DOOR LOCKED" icon will flash; "CLEAN", icon and the letters "CLn" will remain on in the display (Fig. 2). 4. As soon as the control is set, the motor driven oven door lock will begin to close automatically. Once the door has been locked the "DOOR LOCKED" indicator light will stop flashing and remain on. Also, the oven icon will appear in the display (Figure 3). Note: Allow about 15 seconds for the oven door lock to close. Fig. 3 Note: If the optional delay Self=Clean feature is needed, finish steps 5=7. If Self=Clean is started immediately skip the remaining steps and continue with "When the Self-Clean cycle is done" on the following page. 5. Press @ (Fig. 4). Enter the desired Self-Clean starting time using the number pads @ @ @ (Fig. 5). 6. Press _. "Gin" icon will turn off; "DELAY", "DOOR LOCKED", "CLEAN" and Cooktop locked icons will remain on. 7. The control will calculate forward from the set start time to determine when the Self-Cleaning cycle should end. The SelfCleaning cycle will turn on automatically at the set time. At that time the icon "DELAY" will go out; the oven icon will come on, the start time, "CLEAN" and "CLn" will remain in the display (Fig. 6) @ Q@@ Fig. 4 Fig. 5 Fig. 6 27