Kenmore 4813 Use and Care Guide - Page 6

Oven Vent and Racks Upper Oven Vent Location Some models are equipped with a blower which runs in baking and self=cleaning mode to keep all internal components at a cool temperature. The blower may keep running even if the oven has been turned off, until the components have cooled down. On 30" double wall ovens, the blower in both ovens will start when using one of the ovens in self=clean mode. Oven Vent Location Each oven is vented at its upper front frame. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Arranging Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. Lower Oven Vent Location To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out. To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place. Types of Oven Racks Always use pot holders or oven mitts when adjusting the oven racks. Wai until the oven has completely cooled if possible. Oven racks may HOT and cause burns. .._/_,.._ Your appliance may be equipped with one or more of the oven rack types shown; Flat Handle Oven Rack and Offset Oven Rack (some models). To maximize cooking space the offset rack can be used in the Iowet rack position to roast large cuts of meat and poultry. Flat Handle Oven Rack Air Circulation in the Oven If using 1 rack, place in center of oven. If using multiple racks, stagger cookware as shown. Offset Oven Rack (some models) For best air circulation and baking results allow 2-4" (5-10 cm) around the cookware for proper air circulation and be sure pans and cookware do not touch each other, the oven door, sides or back of the oven cavity. The hot air must circulate around the pans and cookware in the oven for even heat to reach around the food. 1 Oven Rack Multiple Oven Racks