Kenmore 4813 Use and Care Guide - Page 8

Setting the Clock Setting the Clock The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day v operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash. Press _. The display will stop flashing, INSTRUCTIONS To set the clock (example below for 1:30) PRESS 1. Press ("'_, "CLO" will appear in the display (Fig. 1). (_ , Press pads to set the time of day to 1:30 (Fig. 2). Press _. The time of day will appear in the display (Fig. 3). Changing between 12 or 24 hour time of day display 1. Press and hold _ in the display. for 7 seconds until "12h" or "24h" appears 2. Press _ to switch between the 12 and 24 hour time of day display. The display will show either "12h" (Fig. 4) or "24h" (Fig. 5). _ f'-_ 3. Press (,_TAR_to accept the change or press (STOPto) reject the v v change. 4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours. _ @ or DISPLAY Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5