Kenmore 5850 Use and Care Guide - Page 23

PERFORMANCE DATA SHEET Base Grille Water Filtration System Model T1 KB2iTIRFKB2 Capacity 200 Gallons (757 Liters) without Filter Indicator Light of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSl Standard 53 for the (_ Sreydsutectmion tesotfedLeaadn,d Mceerrtcifuierdy, AbtyraNziSnFe, InBteernzaetinoen,al Toaxgaapihnesnt e, NSOF/-ADNicShIloroSbteanzdeanrde, 42 Cfoyrststh, e Truerdbuidcittiyo,n Asbestos, Lindane, Tetrachloroethylene, Endrin, Alachlor, Chlorobenzene and Ethylbenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSl Standards 42 and 53. Substance Reduction NSF Reduction Average Aesthetic Effects Requirements Influent Influent Challenge Concentration Maximum Effluent Average Effluent Minimum % Average % Reduction Reduction Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 2.0 mg/L 3533333#/mL Average Influent 150 ug/L 157 ug/L 2.0 mg/L _+10% At east 10,000 part c es/mL Influent Challenge Concentration 0.15 mg/L _+10% 0.15 mg/L _+10% 0.08 mg/L ** 22000 #/mL Maximum Effluent 1.0 ug/L 2.0 ug/L 2.0 mg/L 11567 #/mL Average Effluent 1 ug/L 1.08 ug/L 95.93 99.38 Minimum % Reduction 99.33 98.72 97.36 99.67 Average % Reduction 99.33 99.31 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene Toxaphene 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 0.003 mg/L 0.0058 mg/L 0.0057 mg/L 15 ug/L 1750 ug/L 15 ug/L 0.006 mg/L _+10% 0.006 mg/L _+10% 0.015 mg/L _+10% 1.8 _+10% 0.015 _+10% 0.0002 mg/L 0.0002 mg/L 0.5 ug/L 1.0 ug/L 1.0 ug/L 0.0002 mg/L 0.0002 mg/L 0.5 ug/L 1.0 ug/L 1.0 ug/L 96.53 96.5 96.67 99.94 93.33 96.53 96.5 96.67 99.94 93.33 Atrazine Asbestos 0.003 mg/L 99% 10 ug/L 101 MFL 0.009 mg/L _+10% 1OTto 10_fibers/L tt 2 ug/L 0.17 MFL 2 ug/L 0.17 MFL 80.8 99.83 80.8 99.83 Live Cysts; Turbidity Alachlor >99.95% 0.5 NTU 0.002 mg/L 120,000/L 11.4 NTU 41.3 ug/L 50,000/L min. 11 _+1 NTU 0.04 _+10% 8/L _ 0.41 NTU 0.2 ug/L 1/L; 0.24 NTU 0.2 ug/L 99.99 96.4 99.52 >99.99 97.89 99.52 Endrin Ethylbenzene Lindane Chlorobenzene 0.002 mg/L 0.7 mg/L 0.002 mg/L 0.6 mg/L 5.9 ug/L 1867 ug/L 1.9 ug/L 2.0 ug/L 0.006 _+10% 2.1 _+10% 0.002 _+10% 2.0 _+10% 0.5 ug/L 0.70 ug/L 0.02 ug/L 0.0005 ug/L 0.3 ug/L 0.0588 ug/L 0.02 ug/L 0.0005 ug/L 91.5 99.96 98.93 99.98 95.47 100 98.93 99.98 Tetrachloroethylene 0.005 mg/L 14.2 ug/L 0.015 _+10% 0.5 ug/L 0.5 ug/L 96.47 96.47 Test Parameters: pH = 7.5 + 0.5 unless otherwise noted. Flow = 0.5 gpm Temp. = 68°F to 71.6°F (20°C to 22°C). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • Model T1 KB2: Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often. Use replacement cartridge T1 RFKB2, part #9030. In Canada, use replacement cartridge T1 RFKB2, part #9030B. 2008 suggested retail price of $44.99 U.S.A./S50.99 Canada. Prices are subject to change without notice. • These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. • The product is for cold water use only. • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. • Refer to the front cover or "Accessories" section for the Manufacturer's name, address and telephone number. • Refer to the "Warranty" section for the Manufacturer's limited warranty. (1.9 Lpm). Pressure Application Water Supply Water Pressure Water Temperature Service Flow Rate = 60 psig (413.7 kPa). Guidelines/Water Supply Parameters City or Well 30 - 120 psi (207 - 827 kPa) 33 ° - 100°F (0.6 ° - 37.8°C) 0.5 gpm (1.9 L/min) @ 60 psi *Class I particle size: >0.5 to