Kenmore 5850 Use and Care Guide - Page 9
Style2-Connection
View all Kenmore 5850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Style2 - Connectiotno WaterLine 1. Unplugrefrigeratoorrdisconnepcot wer. 2. Removaenddiscartdheblacknylonplugfromthegraywater tubeonthereaor ftherefrigerator. 3. Ifthegraywatetrubesuppliewdiththerefrigeratiosnr otlong enougha,1/4x"1/4("6.35mmx 6.35mm)couplinigsneeded inordetroconnectht ewatetrubingtoanexistinhgousehold watelrineT. hreatdheprovidendutontothecouplinognthe endofthecoppetrubing. NOTET:ightetnhenutbyhandT. hentightenitwithawrench twomoreturnsD. onotovertighten. Complete the Installation Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. AB C A. Refrigerator water tubing B. Nut (provided) C. Bulb D. Coupling (provided) D E FG E. Ferrule (purchased) F. Nut (purchased) G. Household water line 4= Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Flush the water system. See "Prepare the Water System." NOTE: It may take up to 24 hours for your ice maker to begin producing ice. Style 3 - Connection to Shut-off Valve 1. Unplug refrigerator or disconnect power. 2. Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator. 3. Thread the provided nut onto the water valve as shown. NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. Please read before using the water system. Immediately after installation, follow the steps below to make sure that the water system is properly cleaned. 1. Open the freezer door and turn off the ice maker by lifting up the wire shutoff arm as shown. A J/ I B A. Bulb B. Nut (provided) 4= Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak. NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. 2= Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. NOTE: As air is cleared from the system, water may spurt out of the dispenser. 3= Open the freezer door and turn on the ice maker by lowering the wire shutoff arm. • Allow 24 hours to produce the first batch of ice. • Discard the first three batches of ice produced. • Depending on your model, you may want to select the maximum ice feature to increase the production of ice.