Kenmore 7560 Installation Instructions - Page 1

Kenmore 7560 - Elite 40 in. Dual Fuel Range Manual

Page 1 highlights

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. iNSTALLER. if the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. FOR YOUR SAFETY: = Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. = WHAT TO DO iF YOU SMELL GAS: • Do not try to light any appliance. = Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • if you cannot reach your gas supplier, call the fire department. = Installation and service must be performed bya qualified installer, service agency or the gas supplier. RANGE OVERALL DIMENSIONS 47-3/4" Maximum 253/4" 36 + 1/8" Wall on Either Side of Range Above 36" Height. * Note: 3" Clearance if Equipped 2" with 11000 or greater BTU Burners. 30" Minimum e ALL RANGES CAN TiP • INJURYTO PERSONS COULD RESULT • iNSTALL ANTI=TIP DEVICE PACKED WiTH RANGE • SEE iNSTALLATiON iNSTRUCTiONS FRONT SIDE VIEW t Minimumto 18" CEaitbhiener tsSidoen of Range. 14-13"-_1 fMoraxiCmaubminetsDepth Above Range Top. Clearances and Dimensions 1. Location--Check location where the range will be installed. Check for proper electrical and gas supply, and the stability of the floor. 2. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level. Provide Proper Fuel Type Before Proceeding: Your range is preset to operate on natural gas only. This model was shipped convertible from the factory with the necessary parts and conversion instructions supplied, DO NOT attempt to convert this range to L P/Propane settings without the proper LP/Propane conversion kit provided with the range or obtained from your dealer, Follow all instructions provided with this conversion kit. PIN 316259314 (0112) EspaSoI-Paginas9-16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

iNSTALLATiON
AND
SERVICE
MUST
BE
PERFORMED
BY
A
QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE
FOR
LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ
AND
SAVE
THESE
iNSTRUCTiONS
FOR FUTURE
REFERENCE.
if
the
information
in
this manual
is
not followed
exactly,
a
fire
or
explosion
may
result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
=
Do
not
store or
use gasoline
or other flammable vapors
and liquids in
the
vicinity of
this or
any other appliance.
=
WHAT TO DO iF YOU SMELL GAS:
Do
not try to
light any appliance.
=
Do
not touch
any
electrical
switch;
do not
use any phone
in your building.
Immediately
call
your
gas
supplier
from
a neighbor's
phone.
Follow
the
gas supplier's
instructions.
if you
cannot
reach
your
gas
supplier,
call
the
fire
department.
=
Installation and service must
be
performed
bya
qualified
installer, service agency or
the gas
supplier.
e ALL
RANGES
CAN
TiP
INJURYTO
PERSONS
COULD
RESULT
• iNSTALL
ANTI=TIP
DEVICE
PACKED
WiTH
RANGE
• SEE iNSTALLATiON
iNSTRUCTiONS
RANGE
OVERALL
DIMENSIONS
253/4"
47-3/4"
Maximum
36 + 1/8"
FRONT
Wall
on Either
Side of
Range
Above
36"
Height.
* Note:
3"
30"
Clearance
Minimum
if
Equipped
2"
with
11000
or
greater
BTU Burners.
SIDE
VIEW
t
Minimumto
14-13"-_1
18"
Cabinets
on
Maximum
Depth
Either Side
for Cabinets
of
Range.
Above
Range
Top.
Clearances
and
Dimensions
1.
Location--Check
location
where
the range will be
installed.
Check
for
proper
electrical
and
gas
supply,
and
the
stability
of
the
floor.
2.
Dimensions
that are shown
must
be
used.
Given
dimensions
provide
minimum
clearance.
Contact
surface
must
be
solid
and level.
PIN 316259314
(0112)
Provide
Proper
Fuel
Type
Before
Proceeding:
Your
range
is
preset to operate
on natural gas only.
This
model
was shipped
convertible
from the factory
with the necessary
parts and
conversion
instructions
supplied,
DO NOT attempt to convert this range to L P/Propane settings without
the proper LP/Propane conversion
kit provided with the range or obtained from your
dealer,
Follow all instructions
provided with this conversion
kit.
EspaSoI-Paginas9-16