Kenmore 7759 Owners Manual - Page 13
Drain Opening, in Freezer Compartment, Under, Refrigerator, Light Bulb Replacement - sears
View all Kenmore 7759 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Drawer Removal Light Bulb Replacement Drawers will stop before coming all the way out of the refrigerator to help prevent contents from spilling onto the floor Drawers can easily be removed by tilting up slightly and pulling past "stop" location On some models you may need to remove the door bins from the fresh food door before removing the drawers When replacing the drawers make sure you stide them through the drawer guides on the left side If the door prevents you from taking out the drawers, the refrigerator will need to be rolled forward until the door opens enough to sfide the drawers out In some cases when you roll the refrigerator out you will need to move the refrigerator to the left as you roll it out Drain Opening in Freezer Compartment When cleaning, remove the freezer bin and flusha solution of baking soda (one teaspoon [5 mill and two cups (500 ml) of hot (not boiling) water through the drain line with the help of a meat baster This will help eliminate odor and reduce the likelihood of a clogged drain line. If drain becomes clogged, use a meat baster and baking-soda-and-water solution to force the clog through the drain line Under Refrigerator The condenser is located behind the base grille For most efficient operation, remove the base grille (see page 3} and sweep away or vacuum up dust that is readily accessible For best results, use a brush specially Clean the condenser coils at least once a year designed for this purpose It is available at your Sears store or service center This easy cleaning operation should be done at least once a year Behind Refrigerator Take care moving your refrigerator away from the wall All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces_ Pu!l the refrigerator straight out and return it to position by pushing it straight in Moving refrigerator in a side direction may damage floor covering or refrigerator,, Unplug refrigerator before changing a light bulb_ Fresh Food Compartment-Upper Light 1. Pull off temperature control knobs 2o Pull the bottom Pin of the light shield down and forward, then rotate the top up and off After replacing with same size bulb, reinstafl light shield, Fresh Food Compartment--Lower Light (on somemodels) This light is located behind the top drawer or right above the top drawer (depending on your model), 1. Unplug the refrigerator- 2. If the light is behind the top drawer you will need to remove the drawer and the shelf above it, To remove the drawer see the Drawer Removal section in Care and Cleaning • To remove the shelf first remove any food on the shelf, Then tilt lhe shelf up at the front and lift it up and out of the tracks, 3, Grasp the bottom of the light shield and pull it forward and up 4. After replacing wilh the same size bulb, replace the shield If you cannot locate the correct bulb, see your dealer, 5. tf the light was behind the top drawer, you will need to replace the drawer and the shelf above it, • To replace the sheff, raise the shelf front slightly and place the top hooks in the lowest large track slots. Then lower the front of the shelf until it is level 6. Plug the refrigerator back in Freezer Compartment 1. Remove shelf just below light panel. (Shelf will be easier to remove if it isemptied first ) 2o Pull plastic light panel toward you (it will bend to free tabs from grooves.) 3. After replacing with same size bulb, reinstall panel and shelf, When pushing the refrigerator back, make sure you don't roll over the power cord or icemaker supply fine, 13