Kenmore 9747 Use and Care Guide - Page 28

Setting Warmer Drawer Controls • • Warmer Drawer Humidity Controller (some models) Removing & Replacing Warmer Drawer (some models) Warmer Drawer Humidity Controller Feature (some models) This feature may be used to control humidity levels in the Warmer Drawer. The control knob is located on the inner front panel of the Warmer Drawer. To help keep foods moist, move the handle to the right. This closes the vents and helps keep the moisture inside the Warmer Drawer. For crisp foods, move the handle to the left. This opens the vents and allows more of the moisture to escape. For Moist Heat: Slide the humidity control knob in the direction of (More) (See Fig. 1). This will help keep the food in the Warmer Drawer from drying out. Both heat and moisture will be applied to the Warmer Drawer cavity. For Dry Heat: Slide the humidity control knob in the direction of (Less) Fig. 2). This allows more of the moist heat to escape and provides a dryer environment for the food in the Warmer Drawer. (See Fig. 2 Fig. 1 Note: For some types of servings you may want to store previously prepared food in a "dry heat" environment. For frequent controller adjustments, slightly loosen humidity controller knob and slide to any desired position. To maintain a desired setting, adjust controller knob into position and tighten knob. Pull up with finger Warmer (Warm & Ready TM) Drawer Indicator Light (some models) Left Glide The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not come on during the Self-Clean cycle. Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer d rawer. Remove shield on right glide. Pull up on left lever on while pushing down right lever, To Remove and Replace (some models) To Remove Warmer 1. 2. 3. Fig. 3 Warmer (Warm & Ready TM) Drawer Drawer: Push down with finger 4. 5. _ Turn powerOFF before removing thewarmerdrawer. Open the drawer to the fully opened position. On the right glide you will find a shield attached with a hex-head screw (See Fig. 3). Use a 1/4" socket and ratchet remove the shield. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever. Pull the drawer away from the range. Drawer: Glide To Replace Warmer 1. 2. 3. 4. Fig. 4 NOTE: The Warmer Drawer will NOT operate while in the Self:Clean and ,'Oven Lockout" modes Replace shield on the right glide of the drawer body. Pull the bearing glides to the front of the chassis glide (See Fig. 4). Align the glide on each side of the drawer with the glide slots on the range. Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 2=4. This will minimize possible damage to the bearing glides. 28