Kenwood 9050S Instruction Manual - Page 21

Normal playback Input level adjustment (analog sources only) MULTI CONTROL Adjusting the sound BASS BOOST LOUDNESS TONE MULTI CONTROL Input SOUND Selector keys SOUND MULTI Input Selector keys PHONES ACTIVE EQ BASS BOOST MUTE TONE VOLUME CONTROL MULTI %/ fi VOLUME %/fi MUTE ACTIVE EQ LOUDNESS Input level adjustment (analog sources only) If the input level of an analog source signal is too high, the CLIP indicator will blink to indicate the source signal. Adjust the input level. SP MUTE L C R A B CLIP LFE SL S SB SR 1 Use the Input Selector keys to select the source of which the input level you want to adjust. • You can store a separate input level for each input source. 2 Press the SOUND and ∧/∨ keys or MULTI @/# keys repeatedly until the "INPUT" indication appears. 3 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the input level. SP MUTE L C R A B CLIP LFE DOLBY PL II x SL S SB SR • The adjustment mode is displayed for approximately 20 seconds. • The input level may be adjusted to any one of three settings: 0dB, -3dB, and -6dB. (The initial setting is 0dB.) 4 Press the SOUND key again to return to the input indication. Adjusting the TONE You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. 1 Press the TONE key to select the TONE mode. 2 Use the MULTI CONTROL knob or MULTI %/fi keys to select TONE ON/OFF. SP MUTE L C R A B CLIP LFE SL S SB SR STEREO 3 When in TONE ON selection, press the TONE key for the following displays. BASS : Select this to adjust the low frequency range. TREBLE : Select this to adjust the high frequency range. 4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the sound quality. SP MUTE L C R A B CLIP LFE SL S SB SR STEREO • The bass and treble levels are adjustable from -10 to +10 in 2 step increments. • The adjustment item is displayed for approximately 20 seconds. • This function is available only for speakers connected to FRONT A terminals. Adjusting the LOUDNESS mode You can adjust the Loudness function which controls the low volume settings to maintain the music's richness. The adjustment can be made when the receiver is in the PCM stereo and analog stereo mode. Press the LOUDNESS key to turn the LOUDNESS setting ON. • This function is available only for speakers connected to FRONT A terminals. To cancel Press the LOUDNESS key again so that the "LOUDNESS" indicator goes off. 21 EN