Kenwood 9050S Instruction Manual - Page 23

Recording Recording audio (digital sources) For REC MODE AUTO : Switch on the REC MODE to record a digital input source. SP MUTE AUTO DETECT DIGITAL STEREO Usually use the REC MODE AUTO to record audio input sources. When L C R A B CLIP LFE the digital mode changes during recording in the REC MODE AUTO, the audio input source may be interrupted momentarily. SL S SB SR Recording music in REC MODE AUTO or MANUAL DIMMER SP MUTE AUTO DETECT DIGITAL L C R A B CLIP LFE SL S SB SR For REC MODE MANUAL : SP MUTE L C R A B CLIP LFE SL S SB SR DIGITAL STEREO STEREO Input Selector keys Input Selector keys SP MUTE L C R A B CLIP LFE SL S SB SR DIGITAL STEREO 4 Start playback, then start recording. • If the audio reproduction stops in the middle due to change in the input signals, etc., press the DIMMER key. 1 Use the Input Selector keys to select the source (CD/DVD, DVD/ 6CH, VIDEO 2, VIDEO 3) you want to record. 2 Set the MD or TAPE recorder to record. 3 Press and hold the DIMMER key for more than 2 seconds to select the REC MODE AUTO or MANUAL. 1 REC MODE off : The digital input record mode is switched off. 2 REC MODE AUTO : The digital input signals (DTS, Dolby Digi- tal, or PCM) are identified automatically and converted into stereo signals that are ready for recording. 3 REC MODE MANUAL : The input signal type at the moment this mode is selected is held throughout this mode. • When the REC MODE MANUAL is selected, the digital input signal is converted to stereo signals (down-mix). But once the digital signal is changed to other signal, no signal is output. When the REC MODE AUTO is selected, the digital input signal is converted to stereo signals even if the digital signal is changed. 23 EN