Kenwood CT-403 User Manual - Page 10

Listening to cassette tapes 10 The figure shows an example for the CT-403 or KXF-W3030 POWER PUSH/OPEN 0 PUSH/OPEN 0 (dB) - -5 0 +3 +6 (dB) 1¡ @ 7 # TAPE A AUTO REVERSE TAPE B AUTO REVERSE 1 ¡ 8PAUSE ¶REC/ARM @ 7 # : Keys or controls to be used in this operation Preparation 1 Set the POWER switch to ON. POWER - ON - OFF 2 Load a cassette tape in deck A or B. (Normal playback) Load cassette tapes in both decks. (Relay playback) Press the area marked PUSH/OPEN 0. PUSH0/OPEN (dB) - DOLBY NR -5 0 1 ¡ 8P 77 REC L PUSH0/OPEN (dB) - DOLBY NR -5 0 1 ¡ 8 77 REC ÷ Be sure to remove tape slack before insertion. ÷ The type of tape, that is, the Normal, High position or Metal position (playback only) is selected automatically. ÷ This unit cannot record sound on a Metal tape. PUSH0/OPEN (dB) - DOLBY NR -5 1 ¡ 77 ÷ Be sure to close the cassette holder securely by pushing it. Normal playback 1 Determine the playback conditions. 1 Select the Dolby NR mode. (dB) - -5 0 +3 +6 (dB) DOLBY NR 2 Select the playback mode. (CT-403/KXF-W3030 only) (dB) - -5 0 +3 +6 (dB) REV.MODE 2 Start playback. CT-403 /KXF-W3030 @ 7 # CT-401 /KXF-W1030 or 3 ÷ Set to OFF the Dolby NR key when playing a tape recorded without using Dolby NR. 1 Dolby NR on 2 Dolby NR off Dolby NR on Dolby NR off DOLBY NR DOLBY NR Lit Goes off ÷ Each press switches the indication. 1 "[" :Double-side playback which stops tape after having played both sides. 2 """ :Playback is endless. 3 """ :One-way playback which stops tape after having played a single side. ÷ Tapes are played in the directions indicated by their respective indicators. (CT-403/KXF-W3030) ÷ Playback stops automatically at the end of tape. (CT-401/KXF-W1030)