Kenwood CT-403 User Manual - Page 14

How to record (deck B only) Since this unit is not designed for use with metal tapes, recording on metal tapes cannot be carried out. 14 Preparation A Insert a tape in deck B. PUSH/OPEN 0 (dB) - -5 0 +3 +6 (dB) TAPE B AUTO REVERSE 1 ¡ 8PAUSE ¶REC/ARM @ 7 # The figure shows an example for the CT-403 or KXF-W3030 POWER PUSH/OPEN 0 PUSH/OPEN 0 (dB) - -5 0 +3 +6 (dB) 1¡ @ 7 # TAPE A AUTO REVERSE TAPE B AUTO REVERSE 1 ¡ 8PAUSE ¶REC/ARM @ 7 # : Keys or controls to be used in this operation 1Set up the cassette deck. 1 Select the Dolby NR mode. (dB) - -5 0 +3 +6 (dB) DOLBY NR 2 Select the recording mode. (CT-403/KXF-W3030 only) (dB) - -5 0 +3 +6 (dB) REV.MODE 2 Select the source to be recorded. 3 Set the recording level. 1 Play a music source. 2 Enter the record-pause mode. (dB) - -5 0 +3 +6 (dB) 8PAUSE ¶REC/ARM ÷ Press to record with the DOLBY NR. 1 Dolby NR on 2 Dolby NR off Dolby NR on DOLBY NR Dolby NR off DOLBY NR Lit Goes off ÷ Each press switches the indication. 1 "[" :Double-side recording which stops tape after having recorded both sides. 2 """ :Recording stops after having recorded both sides. 3 """ :One-way recording which stops tape after having recorded a single side. ÷ While pressing the PAUSEkey, press the REC/ARM key. 3 Adjust the recording level. (dB) - -5 0 +3 +6 (dB) REC LEVEL MIN MAX 4 Stop playing the source. 4 Start recording. 1 Play the music source from the beginning. 2 Press the ÷REC/ARM key. Press once. ¶REC/ARM (dB) - -5 0 +3 +6 (dB) ÷ Adjust so that segments around the 0 dB segment of the peak level meter light up at times. (dB) -5 0 +3 +6 (dB) ÷ Recording will start. ÷ The deck enters the stop mode automatically when the tape has been recorded till the end. (CT-401/KXF-W1030)