Kenwood DDX315 Operation Manual - Page 51
Insta
View all Kenwood DDX315 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
CONNECTION/INSTALLATION R Supplied accessories for installation 1 Wiring harness x 1 2 Trim plate*1 x 1 3 Extension wire (2 m) x 1 4 Flat head screws (M5 x 8 mm) x 6*2 5 Round head screws (M5 x 8 mm) x 6 6 Steering Remote cable x 1 7 Microphone (3 m)*3 x 1 *1 Only for DDX4015BT. *2 Only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/DDX315/ DDX315M. *3 Only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/ DDX615WBT/DDX615WBTM. R Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Connect the wiring harness wires in the following order: ground, battery, ignition. 5 Connect the wiring harness connector to the unit. 6 Install the unit in your car. • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 7 Reconnect the · battery. 8 Press the reset button. 9 Configure . (Page 4) Installing the unit R Installing the unit using the mounting bracket removed from the car 4* or 5 Car Bracket 4* or 5 • Select the appropriate type of screw for the mounting bracket: flat head (4)* or round head (5). * Supplied only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/ DDX315/DDX315M. R Installing the trim plate (Only for DDX4015BT) 1 Attach the trim plate (2). 2 ENGLISH 51