Kenwood DMX5020BTS Instruction Manual - Page 43

ÑÑMicrophone unit 1) Check the installation position of the microphone (accessory 1). 2) Clean the installation surface. 3) Remove the separator of the microphone (accessory 1), and stick the microphone to the place shown below. 4) Wire the microphone cable up to the unit with it secured at several positions using tape or other desired method. 5) Adjust the direction of the microphone (accessory 1) to the driver. 1 Connection/Installation ÑÑRemoving the unit 1) Remove the trim plate by referring to step 1 in "Removing the trim plate". 2) Insert the extraction key (accessory 5) deeply into the slot as shown. (The protrusion at the tip of the extraction key must face toward the unit.) 5 3) With the inserted extraction key secured, insert the other extraction key into the slot. Fix a cable with a commercial item of tape. NOTE • Swap the clips if necessary. 5 4) Pull out the unit halfway. ÑÑRemoving the trim plate 1) Use the extraction key (accessory 4) to lever out the four tabs (two on the left part, two on the right part). 4 NOTE • Be careful to avoid injury from the catch pins on the extraction key. 5) Pull the unit all the way out with your hands, being careful not to drop it. 2) Pull the trim plate forward. English 43