Kenwood DMX7017DABS Instruction Manual - Page 80
Wiring harness Accessory, connector function guide, way speaker system setup
View all Kenwood DMX7017DABS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Connection/Installation ÑÑWiring harness (Accessory 1) connector function guide Pin Color and function A-4 Yellow Battery A-5 Blue/White [2] Power Control A-6 Orange/White Dimmer A-7 Red Ignition (ACC) A-8 Black Earth (Ground) Connection B-1/ B-2 Purple (+) / Purple/Black (-) Rear Right B-3/ B-4 Gray (+) / Gray/Black (-) Front Right B-5/ B-6 White (+) / White/Black (-) Front Left B-7/ B-8 Green (+) / Green/Black (-) Rear Left *Speaker Impedance: 4-8 Ω #WARNING for Connecting the ISO Connector The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. The default connection for the wiring harness is described in (1) below. If the ISO connector pins are set as described in (2), make the connection as illustrated. Please be sure to reconnect the cable as shown (2) below to install this unit to the Volkswagen vehicles etc. (1): Default setting The red (A-7 pin) of the vehicle's ISO connector is linked with the ignition, and the yellow (A-4 pin) is connected to the constant power supply. Red (Ignition cable) Red (A-7 pin) Unit Vehicle Yellow (Battery cable) Yellow (A-4 pin) (2) The red (A-7 pin) of the vehicle's ISO connector is connected to the constant power supply, and the yellow (A-4 pin) is linked to the ignition. Red (Ignition cable) Red (A-7 pin) Unit Vehicle Yellow (Battery cable) Yellow (A-4 pin) ÑÑ3 way speaker system setup Subwoofer Preout Mid Range Preout Tweeter Preout When connecting to an external amplifier, connect its ground wire to the car's chassis to avoid damaging the unit. Preout RCA Cable (Sold separately) Power amplifier (optional accessory) Speaker Input White + White/Black To mid range left speaker Gray + Gray/Black To mid range right speaker Green + To tweeter left speaker Green/Black Purple + To tweeter right Purple/Black speaker Speaker impedance: 4-8 Ω NOTE • For speaker system setup, see 3 way speaker system setup (P.65). • For speaker setup and crossover setup, see Controlling Audio (P.63). • For how to connect speaker wires to terminals other than speaker terminals and Preout terminals, see Connecting the system and external components (P.81) and Connecting wires to terminals (P.79). 80