Kenwood DPX-MP4070 Instruction Manual - Page 37
Tuner source, Cassette tape source
View all Kenwood DPX-MP4070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Tuner source ? Radio reception is poor. The car antenna is not extended. Pull the antenna out all the way. The antenna control wire is not connected. Connect the wire correctly, referring to the section on 'Connecting Wires to Terminals'. ? The desired frequency can't be entered with the Direct Access Tuning. A station that can't be received is being entered. Enter a station that can be received. You're trying to enter a frequency with a 0.01 MHz unit. What can be designated in the FM band is to 0.1 MHz. Cassette tape source ? Can't remove tape. The cause is that more than 10 minutes has elapsed since the vehicle ACC switch was turned OFF. The tape can only be removed within 10 minutes of the ACC switch being turned OFF. If more than 10 minutes has elapsed, turn the ACC switch ON again and press the Eject button. ? The DPSS, Tape Advance and Music Repeat don't operate correctly. The space between the songs on the tape can't be recognized because it's too short. Have at least 4 seconds between songs. The space between songs can't be recognized because there's too much noise between songs. Reduce the noise between songs. ? The blank skip doesn't work. Because noise is too loud, the non-recorded part can't be recognized. Reduce the noise between songs. ? Blank Skip functions at places that are recorded. Because the recording level is low, it's recognized as not recorded. Turn Blank Skip OFF. ? 'Music Repeat' (page 20) is cancelled arbitrarily. The power was turned OFF or a source selection or other operation was performed. Music repeat is cancelled when the power is turned OFF or a source selection or other operation is performed. English | 37