Kenwood KDC-MP435U Instruction Manual - Page 35
English - reset code
View all Kenwood KDC-MP435U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
IN (Blink): The CD player section is not operating properly. ➪ Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center. PROTECT: The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated. ➪ Wire or insulate the speaker cable properly and press the reset button. If the "PROTECT" code does not disappear, consult your nearest service center. NA FILE: An Audio file is played with a format that this unit can't support. ➪ ---- COPY PRO: A copy-protected file is played. ➪ ---- DEMO: The Demonstration mode has been selected. ➪ The (page 26) is ON. Turn it OFF. NO DVICE: The USB device is selected as a source although no USB device is connected. ➪ Change the source to any source other than USB. Connect an USB device, and change the source to USB again. NA DVICE: An unsupported USB device is connected. ➪ For the supported USB devices, refer to . NO MUSIC/E-15: • The connected USB device contains no playable audio file. • Media was played that doesn't have data recorded that the unit can play. USB ERR: The connected USB device is rated a current capacity higher than the allowable limit. ➪ Check the USB device with reference to . Some trouble may have occurred to the connected USB device. ➪ Change the source to any source other than USB. Remove the USB device. iPod ERR: Connection to the iPod has failed. ➪ Remove the USB device and then reconnect it. ➪ Confirm that the software for the iPod is the latest version. REMOVE: The Remove mode has been selected for the USB device. You can remove the USB device safely. English | 35