Kenwood KDC-MP435U Instruction Manual - Page 9
Audio Setup, Speaker Setting, Subwoofer Output - aux input
View all Kenwood KDC-MP435U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Display Front High Pass Filter "HPF" Rear High Pass Filter "HPR" Low Pass Filter "LPF" Subwoofer Phase Volume offset Loudness Dual Zone System* "PHAS" "V-OFF" "LOUD" "2ZON" Range Through/40*/60*/80/100/120/ 150/180/220* Hz Through/40*/60*/80/100/120/ 150/180/220* Hz 50*/60/80/100*/120/ Through Hz Reverse (180°)/ Normal (0°) -8 - ±0 (AUX: -8- +8) OFF/ON OFF/ON ⁄ • * Function of KDC-X491 • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.) • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by (page 24). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by (page 8). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the internal auxiliary input. 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "STANDBY" display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Each time you turn the knob, the setting alternates between the settings shown in the table below. Speaker type OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker Display "SP OFF" "SP 5/4" "SP 6*9/6" "SP OEM" 4 Exit Speaker Setting mode Press the [VOL] knob. Subwoofer Output Turning the Subwoofer output ON or OFF. Push the Control knob toward down for at least 2 seconds. Each time you push the knob, Subwoofer output switches ON and OFF. When it is ON, "SW ON" is displayed. English | 9