Kenwood KDC MP638U Instruction Manual - Page 34

Connecting Wires to Terminals To USB device USB connector (1m) ⁄ Do not remove the cap when you do not use the USB cable. The connector will cause the unit to malfunction if it gets in touch with any metallic part of the vehicle. Steering remote control (Light Blue/Yellow) REMO.CONT To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. Rear output L R Front output Sub Woofer output FM/AM antenna input Wiring harness (Accessory1) Fuse (10A) AUX input (Stereo) Use the mini-plug which is stereo type and does not have any resistance. To Kenwood disc changer/ External optional accessory ⁄ To connect these leads, refer to the relevant instruction manuals. White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black To front left speaker To front right speaker To rear left speaker To rear right speaker If no connections are made, do not let the wire come out from the tab. Power control wire (Blue/White) P.CONT Motor antenna control wire (Blue) ANT. CONT TEL mute wire (Brown) MUTE Dimmer control wire (Orange / White) ILLUMI When using the optional power amplifier, connect to its power control terminal. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. To car light control switch Ignition wire (Red) Car fuse box ACC Battery wire (Yellow) Ground wire (Black) · (To car chassis) Ignition key switch Car fuse box (Main fuse) - Battery + 34 | KDC-X792/KDC-X692/KDC-MP738U/KDC-MP638U