Kenwood KDC-X589 Instruction Manual - Page 11

5 Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second. • When the Bass Extend is set to ON, low frequency response is extended by 20%. • You can exit the Audio Control mode at anytime by pressing any button except for [VOL], [ATT] and [ANG] buttons. Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source for adjustment Press the [SRC] button. • *2 You can control this item when "2ZON" of (page 11) is set to "OFF". • *³ KDC-X589/MP5028 only. • *⁴ The Dual Zone System can be used with the Auxiliary input sources shown below. - Internal auxiliary input (KDC-MP5028/MP528 only) - Option CA-C1AX (KDC-X589 only) • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - The channel of sub source is set up by (page 25). - Main source is selected by [SRC] button. - The volume of Front channel is adjusted by [VOL] knob. - The volume of Rear channel is adjusted by (page 10). - The Audio Control has no effect on sub source. 5 Exit Audio Setup mode Press [VOL] knob for at least 1 second. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item for adjustment Press the [VOL] knob. Each time the knob is pressed, the items that can be adjusted switch as shown below. Subwoofer Output Turning the Subwoofer output ON or OFF. Hold down on [AM] of the Control knob for at least 1 second. Each time the button is pressed, Subwoofer output switches ON and OFF. When it's ON, "SW ON" is displayed. • You can control this item when (page 25) is set to "SWPRE SW". (KDC-MP5028/MP528 only) • You can control this item when "2ZON" of (page 11) is set to "OFF". 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Display Front High Pass Filter*2 "HPF" Rear High Pass Filter*2 "HPR" Low Pass Filter*1,2 Subwoofer Phase*1,2 Volume offset Loudness Dual Zone System*4 "LPF" "PHAS" "V-OFF" "LOUD" "2ZON" Range Through/40*³/60*³/80/100/ 120/ 150/180/220*³ Hz Through/40*³/60*³/80/100/ 120/ 150/180/220*³ Hz 50*³/60/80/100*³/120/ Through Hz Normal (0°)/ Reverse (180°) -8 - ±0 OFF/ON OFF/ON • Volume offset: Each source's volume can be set as a difference from the basic volume. • Loudness: Compensating for low and high tones during low volume. When it's ON, "LOUD" indicator is ON. • *1You can control this item when (page 25) is set to "SWPRE SW". (Function of the KDCMP5028/MP528) • *1 You can control this item when (page 11) is set to "SW ON". English | 11