Kenwood KDC-X591 Instruction Manual - Page 27

Other than Standby mode Audio Preset Recall Recalling the sound setup registered by (page 26). 1 Select the source Press the [SRC] button. 2 Enter Menu mode Press the [MENU] button. "MENU" is displayed. 3 Select Audio Preset mode Push the Control knob towards up or down. Select the "A-PRESET" display. 4 Enter Audio Preset mode Press the Control knob for at least 1 second. 5 Select the Audio Preset Recall Push the Control knob towards up or down. Select the "RECALL" display. 6 Recall the Audio Preset Press the Control knob for at least 2 seconds. The "RECALL" display blinks 1 time. 7 Exit Audio Preset mode Press the [MENU] button. ⁄ • The User memory of "System Q" in (page 8) is changed to the value which was recalled. • The source tone memory item of (page 8) is changed to the value which was recalled by the selected source. In Standby mode Demonstration mode Setting Sets the demonstration mode. 1 Select the Demonstration mode Push the Control knob towards up or down. Select the "DEMO" display. 2 Set the Demonstration mode Press the Control knob for at least 2 seconds. Each time you press the knob at least 2 seconds, the Demonstration mode alternates between the settings shown in the table below. Display "DEMO ON" "DEMO OFF" Setting The Demonstration mode function is ON. Exit Demonstration mode (Normal mode). In Standby mode Firmware version display Displaying the firmware version with the unit. 1 Select the firmware version display mode Push the Control knob towards up or down. Select the "F/W VER" display. 2 Display the firmware version Push the Control knob towards right or left. English | 27