Kenwood KDC-X591 Instruction Manual - Page 36

Troubleshooting Guide The messages shown below display your systems condition. EJECT: • No disc magazine has been loaded in the changer. The disc magazine is not completely loaded. • No CD in the unit. NO DISC: No disc has been loaded in the disc magazine. TOC ERR: • No disc has been loaded in the disc magazine. • The CD is quite dirty. The CD is upsidedown. The CD is scratched a lot. READ ERR: • The number of files or folders which are stored in the connected USB device is above the limitation. • The file system of the connected USB device is broken. ➪ Copy the files and folders for the USB device again referring to http://www. kenwood.com/usb/. If the error message is still displayed, initialize the USB device or use other USB devices. E-05: The disc is unreadable. BLANK: Nothing has been recorded on the MD. NO TRACK: No tracks are recorded on the MD, although it has a title. NO PANEL: The faceplate of the slave unit being connected to this unit has been removed. E-77: The unit is malfunctioning for some reason. ➪ Press the reset button on the unit. If the "E-77" code does not disappear, consult your nearest service center. E-99: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason. ➪ Check the disc magazine. And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. LOAD: Discs are being exchanged in the Disc changer. READING: The unit is reading the data on the disc. HOLD: The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping all operation. ➪ Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc will start playing again. IN (Blink): The CD player section is not operating properly. ➪ Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center. PROTECT: The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated. ➪ Wire or insulate the speaker cable properly and press the reset button. If the "PROTECT" code does not disappear, consult your nearest service center. NA FILE: An Audio file is played with a format that this unit can't support. ➪ ---- COPY PRO: A copy-protected file is played. ➪ ---- DEMO: The Demonstration mode has been selected. ➪ The (page 27) is ON. Turn it OFF. NO DVICE: The USB device is selected as a source although no USB device is connected. ➪ Change the source to any source other than USB. Connect an USB device, and change the source to USB again. NA DVICE: An unsupported USB device is connected. ➪ For the supported USB devices, refer to . NO MUSIC/E-15:• The connected USB device contains no playable audio file. • Media was played that doesn't have data recorded that the unit can play. USB ERR: The connected USB device is rated a current capacity higher than the allowable limit. ➪ Check the USB device with reference to . Some trouble may have occurred to the connected USB device. ➪ Change the source to any source other than USB. Remove the USB device. iPod ERR: Connection to the iPod has failed. ➪ Remove the USB device and then reconnect it. ➪ Confirm that the software for the iPod is the latest version. REMOVE: The Remove mode has been selected for the USB device. You can remove the USB device safely. 36 | English