Kenwood KMM-BT305 Instruction Manual 2 - Page 36
Binstallation/connection
![]() |
View all Kenwood KMM-BT305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
INSTALLATION/CONNECTION Part list for installation (A) Faceplate (×1) (B) Trim plate (×1) Installing the unit (in-dash mounting) (C) Mounting sleeve (×1) (D) Wiring harness (×1) Do the required wiring. (Page 31) (E) Extraction key (×2) Hook on the top side Orientate the trim plate as illustrated before fitting. Dashboard of your car Basic procedure 1 Remove the key from the ignition switch, then disconnect the terminal of the car battery. 2 Connect the wires properly. See "Wiring connection" on page 31. 3 Install the unit to your car. See the following "Installing the unit (in-dash mounting)". 4 Connect the terminal of the car battery. 5 Press BSRC to turn on the power. 6 Detach the faceplate and reset the unit within 5 seconds. (Page 3) Bend the appropriate tabs to hold the sleeve firmly in place. Removing the unit 1 Detach the faceplate. 2 Remove the trim plate. 3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the illustration. 30 ENGLISH
![](/manual_guide/products/kenwood-kmmbt205-instruction-manual-2a45324/36.png)