Kenwood TK-7360 Operation Manual - Page 13

2 Press / (if the key assignment list selection is configured as "Enabled") or to select a memory location number. 3 Press S to enter a name for the list number. 4 Press / to select a digit. 5 Press C> to accept the entered digit and move the cursor to the right. • Press A or # to delete an incorrect digit. Press and hold A or # to delete all digits. 6 Repeat steps 4 and 5 to enter the entire name. 7 Press S to accept the name and enter a number. 8 Press / to select a digit. • You can also enter digits directly using the keypad. 9 Press C> to accept the entered digit and move the cursor to the right. • Press A or # to delete an incorrect digit. Press and hold A or # to delete all digits. 10 Repeat steps 8 and 9 to enter the entire number. 11 Press S to accept the number and store the entry. ■ Removing an Autodial Entry 1 Press the key programmed as Autodial Programming. 2 Press / (if the key assignment list selection is configured as "Enabled") or to select a memory location number. 3 Press A or #. • "DELETE" appears on the display. • Additionally, you can press and hold A or # to delete all entries. 4 Press S or to confirm the deletion. REDIALING 1 Press the key programmed as Autodial. 2 Press , then 0. • If there is no data in the redial memory, an error tone will sound. 3 Press the PTT switch to make the call. STUN This function is used when a transceiver is stolen or lost. When the transceiver receives a call containing a stun code, the transceiver becomes disabled. The stun code is cancelled when the transceiver receives a call with a revive code. • "STUN" appears on the display while the transceiver is stunned. 9