Kenwood TK-7360 Operation Manual - Page 16

2 Press the key programmed as Status or Selcall + Status. • When pressing the Status key, the target Fleet/ ID is fixed and cannot be selected. Skip to step 5 to continue. 3 In Selcall mode, press / (if the key assignment list selection is configured as "Enabled") or to select the ID of the station you want to call. • You can also enter the station ID directly by using the keypad. 4 Press S to enter Status mode. 5 Press / (if the key assignment list selection is configured as "Enabled") or to select the status ID you want to transmit. • You can also enter the status ID directly by using the keypad. 6 Press the PTT switch or ■ to initiate the status call. ■ Receiving When a status call is received, the icon will flash and the calling ID or text message will appear on the display. Press any key to return to normal operation. ■ Reviewing Messages in the Stack 1 Press and hold the key programmed as Stack, Selcall, Status, or Selcall + Status. 2 Press / (if the key assignment list selection is configured as "Enabled") or to select your desired message. 3 Press to return to normal operation. SHORT/LONG MESSAGES To send and receive short or long messages, connect the transceiver to a PC. (Ask your dealer for details.) • Short messages can contain a maximum of 48 characters. Received short messages are displayed the same as Status messages and are stored in the same stack memory. A combined maximum of 15 Status calls and short messages can be stored in the stack memory. • Long messages can contain a maximum of 4096 characters and can only be viewed via a PC. GPS REPORT If a GPS unit (NMEA-0183 format) is installed on your transceiver, you can press the key programmed as Send the GPS data to send your location data. 12