Kenwood VR 605 Instruction Manual - Page 11

Setting up the system Digital connections The digital in jacks can accept DTS, Dolby Digital, or PCM signals. Connect components capable of outputting DTS, Dolby Digital, or standard PCM (CD) format digital signals. If you have connected any digital components to the receiver, be sure to read the "Input mode settings" section carefully. 8 GND VIDEO DVD IN VIDEO 2 IN FM 75Ω AM ANTENNA MONITOR OUT L DEEMPHASIS CHANNEL SPACE SYSTEM CONTROL 50µs AM 9kHz FM 50kHz 75µs AM 10kHz FM 100kHz AUDIO DVD CD / DVD OPTICAL VIDEO 2 COAXIAL DIGITAL IN DVD / 6CH INPUT CENTER FRONT SPEAKERS (8-16Ω) CENTER SPEAKER (8-16Ω) + SURROUND SPEAKERS (8-16Ω) + R - - VIDEO 1 IN VIDEO 1 OUT GND PHONO CD / DVD REC OUT PLAY IN REC OUT PLAY IN PLAY IN DVD MD / TAPE VIDEO1 VIDEO 2 FRONT SURROUND SUB WOOFER R SUB WOOFER RED PRE OUT L WHITE C R GREEN GRAY SPEAKERS L BLUE AC OUTLETS AC110V-120V / 220V-240V~ AC 220240V~ AC 110120V~ 50 / 60Hz SWITCHED TOTAL 90W MAX. VOLTAGE SELECTOR DVD CD / DVD OPTICAL VIDEO 2 COAXIAL DIGITAL IN COAXIAL DIGITAL OUT (AUDIO) RF digital demodulator (DEM-9991D) (sold separately) COAXIAL DIGITAL OUT (AUDIO) Component with DTS, Dolby Digital, or PCM COAXIAL DIGITAL OUT Connect the video signal and analog audio signals to the VIDEO 2 jacks. (See "Connecting video components".) 0 DOLBY DIGITAL RF OUT (AUDIO) PCM OUT LD player Optical fiber cable OPTICAL DIGITAL OUT (AUDIO) CD or DVD player To connect an LD player with a DIGITAL RF OUT, connect the LD player to the KENWOOD RF digital demodulator (DEM-9991D). Next, connect the DIGITAL OUT jacks of the demodulator to the DIGITAL IN jacks of the receiver. Connect the video signal and analog audio signals to the VIDEO 2 jacks. (See "Connecting video components".) 11 EN