Kenwood VR 605 Instruction Manual - Page 2

Before applying the power Units are designed for operation as follows. U.S.A. and Canada AC 120 V only Australia AC 240 V only Europe and U.K AC 230 V only China and Russia AC 220 V only Other countries .......... AC 110-120 / 220-240 V switchable* For the United Kingdom Factory fitted moulded mains plug 1. The mains plug contains a fuse. For replacement, use only a 13Amp ASTA-approved (BS1362) fuse. 2. The fuse cover must be refitted when replacing the fuse in the moulded plug. 3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adaptor, or consult your dealer. If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. IMPORTANT : The wires in the mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live Do not connect those leads to the earth terminal of a three-pin plug. * AC voltage selection The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped. Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction. AC voltage selector switch Move switch lever to match your line voltage with a small screwdriver or other pointed tool. GND VIDEO DVD IN VIDEO 2 IN FM 75Ω AM ANTENNA MONITOR OUT L DEEMPHASIS CHANNEL SPACE SYSTEM CONTROL 50µs AM 9kHz FM 50kHz 75µs AM 10kHz FM 100kHz AUDIO DVD CD / DVD OPTICAL VIDEO 2 COAXIAL DIGITAL IN DVD / 6CH INPUT CENTER FRONT SPEAKERS (8-16Ω) CENTER SPEAKER (8-16Ω) + SURROUND SPEAKERS (8-16Ω) + R - - VIDEO 1 IN VIDEO 1 OUT GND PHONO CD / DVD REC OUT PLAY IN REC OUT PLAY IN PLAY IN DVD MD / TAPE VIDEO1 VIDEO 2 FRONT SURROUND SUB WOOFER R SUB WOOFER RED PRE OUT L WHITE C R GREEN GRAY SPEAKERS L BLUE AC OUTLETS AC110V-120V / 220V-240V~ AC 220240V~ AC 110120V~ 50 / 60Hz SWITCHED TOTAL 90W MAX. VOLTAGE SELECTOR Note : Our warranty does not cover damage caused by excessive line voltage due to improper setting of the AC voltage selector switch. As an ENERGY STAR® Partner, Kenwood Corporation has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.This product can save energy. Saving energy reduces air pollution and lowers utility bills. 2 EN Caution : Read this page carefully to ensure safe operation. Safety precautions WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS. THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. For the U.S.A. FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - - Reorient or relocate the receiving antenna. - - Increase the separation between the equipment and receiver. - - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - - Consult the dealer or an experienced radio / TV technician for help. For the U.S.A. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.