KitchenAid KBZU122TSS Use and Care Guide - Page 13
Using Your Outdoor Side Burner - attachments
View all KitchenAid KBZU122TSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
USING YOUR OUTDOOR SIDE BURNER WARNING Lighting the Side Burner 5. You will see the igniter glow. When burner is lit, release the knob. Turn knob to desired setting. 6. Repeat for each of the other burners as needed. IMPORTANT: If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before relighting. Manually lighting the side burner Burn Hazard Do not let the burner flame extend beyond the edge of the pan. Doing so can result in burns. 1. Remove the outdoor side burner cover. 2. Remove the manual lighting extension (see following illustration) and attach a match to the split ring. WARNING Food Poisoning Hazard Do not let food sit for more than one hour before or after cooking. Doing so can result in food poisoning or sickness. 1. Remove the outdoor side burner cover. 2. Make sure control knobs are turned to OFF. 3. Turn the gas supply on. Natural gas or LP gas from a local supply ■ Using gas supply source other than 20 lb LP gas fuel tank: Turn the shutoff valve to open position from the front of gas supply line. 20 lb LP gas fuel tank, if converted See the "Gas Supply Requirements" section. ■ Using a 20 lb LP gas fuel tank: Slowly open the tank valve. NOTE: If flow limiting device activates, your grill may not light. If your grill does light, the flames will be low and will not heat properly. Turn tank valve and all control knobs off and wait 30 seconds. After shutting off the tank, very slowly open tank valve and wait 5 seconds before lighting. 4. Do not lean over the side burner. Push in and turn the control knob to LITE/HI and hold in. 3. Strike the match to light it. 4. Guide the match to the burner you wish to light. 5. Do not lean over the side burner. Push in and turn the burner knob to LITE/HI for the burner closest to the lit match. The burner will light immediately. When burner is lit, turn knob to desired setting. 6. Repeat for each of the other burners as needed. 7. Remove match and replace manual lighting extension inside its holder. IMPORTANT: If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before relighting. If any burners do not light after attempting to manually light them, contact the KitchenAid Customer eXperience Center. See the "Assistance or Service" section. 13