KitchenAid KDTM704ESS Use & Care Guide - Page 11
ProWash™, Tough, Normal, Top Rack Only, Available with, any cycle
View all KitchenAid KDTM704ESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPTION SELECTIONS OPTIONS Sanitizes dishes and glassware in accordance with NSF International NSF/ ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. Only sanitizing cycles have been designed to meet the requirements of the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. There is no intention, either directly or indirectly, that all cycles on a NSF/ANSI 184 certified dishwasher meet the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. The Sani indicator glows at the end of the cycle if the Sani Rinse option was successfully completed. If the indicator does not activate, it is probably due to the cycle being interrupted. (on some models) For added convenience, use for washing a small load of dishes in the top rack to help keep the kitchen continuously clean. CAN BE SELECTED WITH WHAT IT DOES ProWash™ Tough Normal Top Rack Only Increases the main wash temperature from 105°F to 140°F (41°C to 60°C) and the final rinse from 140°F to 155°F (60°C to 68°C). Available with Slightly faster wash any cycle for smaller loads ADDED TIME TO CYCLE*** (HH:MM) MIN MAX :10 :50 ADDED WATER GALLONS (LITERS) 0 - 1.5 (0 - 5.7) -:03 -:08 0 or (on some models) Runs the dishwasher at a later time or Available with Delays the start of a 1:00 24:00 0 during off-peak electrical hours. Select a wash cycle and options. Press the Delay any cycle cycle to the specified time. button. Press START/RESUME. Close the door firmly. NOTE: Anytime the door is opened (such as, to add a dish), the Start/Resume button must be pressed again to resume the delay countdown. Use Control lock to avoid unintended use of the dishwasher between cycles, or cycle and option changes during a cycle. To turn on Lock, press and hold CONTROL LOCK for 3 seconds. The Control Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked. NOTE: You may need to disable Sleep Mode by pressing either Start/Resume or Cancel, or by opening and closing the door before you are able to turn Control Lock off. To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off. NOTE: If your model requires you to press and hold ProScrub Upper, Top Rack Only or Bottle Wash to lock the controls, the Control Lock light will be on when Control Lock is active. ***Cycle times may increase depending on water temperature, heavy soil condition, and options selected. Adding options will add time to the cycle. See the options information. CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS To start or resume a wash cycle If the door is opened during a cycle for any reason or if the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the Start/Resume button is pressed and the door is closed. NOTE: (for models with controls on top of the door) Push door firmly closed within 3 seconds of pressing Start/Resume. If the door is not closed within 3 seconds, the Start/ Resume light will flash, an audible tone will be heard, and the cycle will not start. 11