KitchenAid KDTM704ESS Use & Care Guide - Page 12

CONTROLS AND CYCLE STATUS CONTROL PURPOSE To reset any cycle or options during selection or to cancel a wash cycle after it's started. To turn the audible tones on or off. COMMENTS Press and hold CANCEL/DRAIN to reset any control selections made. See the "Canceling A Cycle After Dishwasher Is Started" and "Changing A Cycle After Dishwasher Is Started" sections. Press and hold the HI TEMP WASH button for 3 seconds to turn the audible tones on or off. Only audible tones for confirming button presses can be turned on/off. Important audible tones, such as indicating a cycle has been interrupted, cannot be deactivated. Dishwasher Feedback Section CONTROLS AND CYCLE STATUS CONTROL PURPOSE The Cycle Status A Indicator Light is used to follow the progress of the dishwasher cycle. It is located on the top of the door. COMMENTS The single indicator light on the front of the door panel (A) will remain blue during wash/rinse, red during dry, and white when complete. The Cycle Status Display is used to follow the progress of the dishwasher cycle, and to show other information. The Time Display is used for estimated cycle time and also for delay hours. Estimated cycle time is displayed in hours and minutes as you make cycle and option selections. After you start the dishwasher, the display counts down the time. After you press the Start/Resume button, the Time Display counts down seconds to close the door. If the door is not closed by the end of the countdown you will hear a series of beeps and the cycle will not start. When you select the Delay feature, the Time Display will give the number of hours followed by an "H". Canceling a Cycle 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door. 2. Press and hold CANCEL/DRAIN button once. The Cancel/ Drain light will light up. 3. Close the door and the dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes. Changing a Cycle After Dishwasher Is Started 1. You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure. 2. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 3. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle. 4. Press CANCEL/DRAIN and wait approximately 2 minutes until the machine drains and the Cancel/Drain light turns off. 5. Select new cycles and options. 6. Press START/RESUME. Adding a Dish After Dishwasher Is Started If your dishwasher has an "Add Dish" indicator: 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop and then completely open the door. 2. Add a dish to the load while the indicator is lit. 3. Press the START/RESUME button and close the door. If the door is not closed before the countdown timer ends you will hear a series of beeps and the dishwasher will not start. If your dishwasher does not have "Add Dish" indicator: 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop and then completely open the door. 2. If the detergent dispenser door is closed you may add a dish. If the detergent dispenser door is already opened an added dish might not be cleaned. 3. Press the START/RESUME button and close the door. If the door is not closed before the countdown timer ends you will hear a series of beeps and the dishwasher will not start. 12