KitchenAid KVIB606DBS Installation Guide - Page 12
Range Hood Care
View all KitchenAid KVIB606DBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
To Deactivate Auto Sense: If the Auto button is lit, press AUTO once to deactivate Auto Sense. The Auto button light will turn Off. If Auto Sense is in Sleep Mode, press AUTO once to deactivate Sleep Mode and turn On the Auto button light. Press AUTO again to deactivate Auto Sense and turn Off the Auto button light. Auto Sense will turn Off automatically after 2 hours of no activation of the Auto Sense system. To reset Auto Sense, press AUTO. Manual Vent Functions Fan Speeds Low Med Hi Boost Press LOW to turn the fan on at Low speed. Press MED to turn the fan on at Medium speed. Press HI to turn the fan on at High speed. Press BOOST to turn the fan on at the highest speed. Boost will automatically turn Off after 10 minutes and the fan will switch to High speed. Timer The range hood can be set to automatically turn off after 15 minutes. 1. Press and hold the desired fan speed button for 2 seconds. The fan will run on the chosen speed for 15 minutes and the fan speed button light will flash continuously. After 15 minutes, the fan will turn Off automatically. 2. Press the desired fan speed button again while the fan timer is running to cancel the fan timer. NOTE: Changing the fan speed or turning Auto Sense On will also cancel the 15-minute timer. Light The range hood has both task and ambient lighting. To operate the lights: 1. Touch LIGHT once to turn the LED task lights On. 2. Touch LIGHT again to turn LED task lights Off. The ambient lights will turn On. 3. Touch LIGHT a third time to turn the ambient lights Off. NOTE: To turn both the task and ambient lights on at the same time, touch and hold LIGHT for 2 seconds. Touch LIGHT again to turn the task and ambient lights Off. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water, or all-purpose cleanser Metal Grease Filter 1. Open the stainless steel panel. Grasp panel at the front corners, and then pull down to disengage the 2 catch pins from the spring catches. The panel is attached at the rear and will rotate down. D ■ Wipe with a damp soft cloth or nonabrasive sponge, and then rinse with clean water and wipe dry. A B A. Metal filters B. Stainless steel panel C C. Catch pins (2) D. Spring catches (2) 12