KitchenAid KVIB606DBS Installation Guide - Page 8

Assemble and Install Range Hood 1. Install transition on top of hood (if removed for shipping) with 2 - 3.5 x 9.5 mm sheet metal screws. NOTE: The range hood assembly must be held in place while installing the screws in the next step. A 6. Install 16 - 4.2 x 8 mm screws, and then tighten to secure. B A A. Mounting screws A. Vent transition B. 3.5 x 9.5 mm screw 2. Position the 4 vertical supports (A) with notches at the bottom, and then attach to the range hood using 16 - 4.2 x 8 mm screws. 3. Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws. B A A Connect Vent System 1. Install vent system. 2. Push duct over the exhaust outlet. Seal all connections with vent clamps. 3. Use caulk to seal all openings. Non-Vented (Recirculating) Installation 1. Attach the air deflector to the upper horizontal support using 4 mounting screws. B A B A. Vertical supports B. Horizontal support 4. Attach a second set of vertical supports (A), and then set the vertical height (B). See "Installation Dimensions" in the "Location Requirements" section to help determine the desired dimension for vertical height (B). Secure with 16 - 4.2 x 8 mm T20® screws. A A B A. Deflector B. Mounting screws 2. Measure the length of 6" (15.2 cm) duct needed to connect the transition to the deflector. NOTE: Vent should fit up inside the deflector 1" (2.5 cm) minimum. 3. Install vent between the transition and the deflector. NOTE: To make vent installation easier, temporarily remove the deflector from the chimney support bracket, and then replace after vent section is in place. 4. Seal all connections with vent clamps. A. Vertical supports B. Vertical height 5. Using 2 or more people, lift the range hood assembly and attach it by snapping the vertical supports to the spring clips in the upper horizontal support bracket that is mounted to the ceiling. 8