KitchenAid KVIB606DSS Use & Care Guide - Page 4

INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Parts needed ■ Home power supply cable ■ 1 - ½" (12.7 mm) UL listed or CSA approved strain relief Tools needed ■ Level ■ Drill ■ Drill 1¼" (3 cm) drill bit 2.4 mm) drill bit if installing into wood ■ Pencil ■ 3 UL listed wire connectors ■ 1 wall or roof cap ■ Metal vent system ■ 2 - 175-watt max heat lamp bulbs ■ Blower motor system - internal or external (see "Blower Motor System" in the "Accessories" section). ■ Wire stripper or utility knife ■ Tape measure or ruler ■ Pliers ■ Caulking gun and weatherproof caulking compound ■ Vent clamps ■ Jigsaw or keyhole saw ■ Flat-blade screwdriver ■ Metal snips ■ Phillips screwdriver ■ Scissors Parts supplied Remove parts from packages. Check that all parts are included. ■ 2 metal grease filters for 36" (91.4 cm) models 3 metal grease filters for 48" (121.9 cm) models ■ Damper ■ 2 - Vent cover support brackets ■ 2 - 10 x 50 mm wall anchor ■ 2 - 8 x 40 mm wall anchor ■ 2 - D5.3 x 20 mm washers ■ 4 - 5 x 45 mm screws ■ 9 - 4.2 x 8 mm screws ■ T20® TORX®† adapter Location Requirements IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located inside the range hood on the rear wall of the range hood. Product Dimensions Vented Installations 11 28.7 cm) Canopy range hood location should be away from strong draft areas, such as windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. 22³⁄₄" (57.8 cm) The canopy range hood is factory set for venting through the roof or through the wall. All openings in ceiling and wall where canopy range hood will be installed must be sealed. For Mobile Home Installations The installation of this range hood must conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or when such standard is not applicable, the standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local codes. 36" (91.4 cm) or 48" (121.9 cm) 32³⁄₈" (82.2 cm) min. 50 128.7 cm) max. 7⁷⁄₈" (20.0 cm) 25" (63.5 cm) †®TORX and T20 are registered trademarks of Saturn Fasteners, Inc. 4