KitchenAid KVIB606DSS Use & Care Guide - Page 8
Install Range Hood, Install Range Hood Internal Blower Motor - parts
View all KitchenAid KVIB606DSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
2. Determine the location where the power supply cable will be run through the wall. Be sure that the location will be covered by the chimney of the range hood. 3. Drill a 1¹⁄₄" (3.2 cm) hole at this location. 4. Pull enough power supply cable through the wall to allow for easy connection to the terminal box. 5. Install the 10" (25.4 cm) square x 10" (25.4 cm) round transition with damper to the top of range hood using the 3 - 4.2 x 8 mm screws. NOTE: Your range hood requires you to purchase either an internal type or an in-line (external type) blower motor system. For internal blower systems, there are blower motor mounting parts in the blower motor installation packet that must be added to the range hood prior to mounting the range hood to the wall. See the "Install Range Hood Internal Blower Motor" section and the instructions supplied with the blower motor. Install Range Hood 1. Remove the grease filter. See "Range Hood Care" section. 2. Using 2 or more people, hang range hood on 2 mounting screws through the mounting slots on back of range hood. A B Install Range Hood Internal Blower Motor NOTE: Your range hood requires you to purchase either an internal type or an in-line (external type) blower motor system. See "Blower Motor System" in the "Accessories" section. Prepare the Internal Blower System IMPORTANT: Perform steps 1-4 before mounting the range hood. 1. Remove grease filters from range hood. See the "Range Hood Care" section in the Use and Care Guide. 2. Install the motor support bracket using three 4.2 x 8 mm screws. Screw bracket to the inside top or back (alternate location on some models), toward the left side of the range hood. 3. Install motor spring clip using two 4.2 x 8 mm screws. Screw spring clip to the inside top or back (alternate location on some models) of the range hood at the proper location for the selected motor system. Slide the mounting tab of the spring clip through the slot in the panel and secure with the screws. Use the inside set of mounting holes for the single motor system. Use the outside set of mounting holes for the dual motor system. B A A. Mounting screws B. Mounting slots 3. Level the range hood and tighten upper mounting screws. 4. Install 2 - 5 x 45 mm lower mounting screws and tighten. DE C A. 4.2 x 8 mm screws (3) for motor support bracket B. 4.2 x 8 mm screws (2) for motor spring clip C. Motor support bracket D. Motor spring clip (single motor assembly location) E. Motor spring clip (dual motor assembly location) 4. Install the 6 mm nuts to the outside top or outside back (alternate location on some models) of the range hood at the proper location for the selected motor system. ■ Two 6 mm nuts are required for the single motor system. Clip nuts into the small square notches located at the left and right end of the square vent opening. A A. Lower mounting screws 8