Kodak 3520D User Guide - Page 24

Dynamic Print Field Options Sequential Document Number-the starting sequential document number is specified by the host during job setup, and has a maximum of nine digits. You may suppress the printing of leading zeros. The sequential number increments by one for each document scanned. If the sequential number rolls over (e.g., three digits are specified, and the number 1000 is reached), the scanner stops and displays an error. Date-this field can be specified to be in MMDDYYYY, DDMMYYYY, or YYYYMMDD format. Date delimiters (dash, slash, comma, or blank separators) may be specified and will be counted as part of the 40-character string length limit. Time-this field is in the format HH:MM, where HH is in 24-hour format. The hours and minutes are separated with a colon (:). This field therefore uses five characters of the 40 character limit. Control of the Printer-any combination of dynamic and static fields is allowed as long as the total print string does not exceed 40 characters. There is no "default" print string. The format of the print string, along with the starting sequential document number, if used, is created on the host and is downloaded to the scanner at the beginning of each scan session. Characters can be printed in two orientations, Cine and Comic, and two sizes, Large and Small. Small is approximately two-thirds the size of normal, and is designed to fit 10 characters per inch when printed in Comic orientation. The resolution of the character fonts is 96 dpi across the width of the scanner. However, the font resolution varies with the direction that the paper is fed into the scanner. This variable allows the creation of an easy-to-read character string. The approximate resolution of the printed output is shown below. Cine Comic Resolution (dpi) Large 63 dpi 85 dpi Small 85 dpi 115dpi 3-2 A-61159 May 2002