Kodak CX6445 User's Guide - Page 97
Adjust the camera Video Out, half-way and hold, the rest of the, way down
View all Kodak CX6445 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Chapter 10 Problem Cause Solution Picture is not clear. The lens is dirty. Clean the lens (page 103). Subject too close when Move so there is at least 19.7 in. taking picture. (50 cm) between the camera and the subject, or at least 3.9 in. (10 cm) at Wide in Close-up mode. Subject or the camera Place the camera on a flat, steady moved while the surface or use a tripod. picture was taken. The subject is too far Move so there is no more than away for the flash to be 16.7 ft (5.1 m) between the effective. camera and the subject; 8.5 ft (2.6 m) in Telephoto. Auto focus was not achieved. To take the best possible pictures, press the Shutter button half-way and hold. When the ready light glows green, press the Shutter button the rest of the way down to take the picture. (If the yellow light blinks, release the Shutter button and recompose picture.) Slide show does not run on external video device. Video Out setting is incorrect. External device is set incorrectly. Adjust the camera Video Out setting (NTSC or PAL, page 63). See the external device's user's guide. Camera freezes Camera detected an up when a card is error when the card inserted or was inserted or removed. removed. Turn the camera off, then back on. Make sure the camera is turned off before inserting or removing a card. 85