Konica Minolta AccurioPress C2070/2070P AccurioPress C2070/C2070P/C2060/Print - Page 106
screen or the, Enter the zoom ratio or the image shift value using the keypad
View all Konica Minolta AccurioPress C2070/2070P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
5.1 Both Sides Adjustment % Press [Front] or [Back] to select the print side to be adjusted. & Enter the zoom ratio or the image shift value using the keypad, [,], or [+] on the screen or the Keypad on the control panel. - To specify the zoom ratio, press [Vertical] or [Horizontal], then enter a value. [Vertical] is used to adjust the zoom ratio in the crosswise direction. [Horizontal] is used to adjust the zoom ratio in the paper feed direction. To enlarge the print side, enter the value with a positive mark (+). To reduce it, enter the value with a negative mark (-). The adjustment value changes 0.01% on a 1-step basis. Adjustment Range: [Vertical] -1.00 to +1.00, [Horizontal] -1.00 to +1.00* * [Horizontal] of [Back] must be specified between -0.80 and +0.20. - To move the print side upward, downward, leftward, or rightward (image shift), press [Up/Down] or [Right/Left], then enter the value. To move the print side upward or rightward, enter the value with a positive mark (+). To move the print side downward or leftward, enter the value with a negative mark (-). The adjustment value changes 0.1 mm on a 1-step basis. Adjustment range: [Up/Down] -10.0 to +10.0, [Right/Left] -3.0 to +3.0 - If [Back Side Magnification Adjustment] is set to [OFF], [Horizontal] of [Back] is not available. - To switch the positive mark (+) and negative mark (-), press [+/-]. - To reset the numeric value you are currently entering, press [Clear]. - Pressing [Reset (Front/Back)] resets all the values you entered in [Front], [Back], or [Rotate/Skew]. - To adjust the zoom ratio and image shift, check the status in the center of a page. 5-24