Home » Konica Minolta Manuals » Printers » Konica Minolta KIP 7170 » Manual Viewer

Konica Minolta KIP 7170 KIP 7170 User Manual - Page 38

Cut Sheet Media

View all Konica Minolta KIP 7170 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

2. 5 Cut Sheet Media 1. Open the Bypass Feeder (1). Bypass Feeder 2. There are several size markings on the table of Bypass Feeder which indicate possible feed positions. Place the cut sheet paper on the table between its concerning size markings then insert it into the Bypass Feeder. When the leading edge touches the feeding roller, the machine automatically carries and sets the paper at the proper position. size markings NOTE (1) As a curly cut sheet will cause a mis-feed, straighten the sheet as far as possible before printing. And set the sheet in "curl down" direction as a mis-feed can be avoided. "Curl up" sheets tend to result in a mis-feed. OK NG Correct (curl down) Incorrect (curl up) (2) Setting a cut sheet to the Bypass Feeder while the printer is processing a print job cause a paper jam. 2-16 Chapter 2 Basic Operation

Section	Page
KIP 7170 Hardware Operation Guide	1
Safety Warnings	3
WARNING	4
CAUTION	5
POWER CORD INSTRUCTION	6
Chapter 1 Before Use	7
1. 1 Installation Requirements	8
1. 2 Originals Prohibited from Duplication	9
1. 3 Features	10
1. 4 Specifications	11
1. 4. 1 General	11
1. 4. 2 Printer part	12
1. 4. 3 Scanner part	14
1. 5 Appearance	15
1. 5. 1 Front view	15
1. 5. 2 Rear view	16
1. 6 Specifications for the Scan Original	17
1. 7 Specifications for the Printing Paper	20
1. 7. 1 Papers not available to use	20
1. 7. 2 Keeping the paper in the custody	21
1. 7. 3 Treatment against environmental condition	22
Chapter 2 Basic Operation	23
2. 1 Turning on KIP 7170	24
2. 2 Turning off KIP 7170	26
2. 3 Replacing Roll Media	27
2. 4 Replacing Toner Cartridge	33
2. 5 Cut Sheet Media	38
2. 6 Copying	39
2. 7 Stop of Scan or Copy	42
2. 8 Canceling Sleep Mode	43
2. 9 Dehumidifying Roll Media	44
Chapter 3 Error Correction	45
3. 1 Mis-feed Error	46
3. 1. 1 Deck Jam / Feeding Jam	46
3. 1. 2 Manual Jam	49
3. 1. 3 Reg. Jam / Internal Jam	51
3. 1. 4 Fuser Jam	53
3. 1. 5 Stack Jam	56
3. 1. 6 Original Jam	58
3. 1. 7 Accessory Jam	59
3. 2 Other Operator Call Error	60
3. 2. 1 Roll Replacement	60
3. 2. 2 Toner Empty	60
3. 2. 3 Scanner Unit Open	60
3. 2. 4 Printer Not Available	60
3. 2. 5 Accessory Error	60
3. 3 Service Call Errors	61
Chapter 4 Maintenance	62
4. 1 Scanner Unit	63
4. 1. 1 Scan Glass, Feed Roller, Guide Plate	63
4. 1. 2 Sensor	66