Home » Konica Minolta Manuals » Printers » Konica Minolta KIP 7170 » Manual Viewer

Konica Minolta KIP 7170 KIP 7170 User Manual - Page 44

Dehumidifying Roll Media, HL

View all Konica Minolta KIP 7170 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

2. 9 Dehumidifying Roll Media If the roll paper is extremely humidified, it may cause several kinds of defective print. Defective prints you will experience most will be "crease of paper" and "loss of image". Normal Print Crease of paper If the media is humidified; Normal Print Loss of image If the media is humidified; If the KIP 7170 is installed in such a condition, it is recommended to use the optional embedded "Dehumidify Heater". Turn on the Dehumidify Heater if the room air has too much humidity (75% or higher) to prevent the above kinds of print defect. Such problems above may be resolved. NOTE KIP 7170 is equipped with the Dehumidify Heater (optional for the US) If needed, contact the service personnel for detail. To turn on the Dehumidify Heater, press the H side of the Dehumidify Heater Switch on the rear. (Press its L side to turn off.) H L 2-22 Chapter 2 Basic Operation

Section	Page
KIP 7170 Hardware Operation Guide	1
Safety Warnings	3
WARNING	4
CAUTION	5
POWER CORD INSTRUCTION	6
Chapter 1 Before Use	7
1. 1 Installation Requirements	8
1. 2 Originals Prohibited from Duplication	9
1. 3 Features	10
1. 4 Specifications	11
1. 4. 1 General	11
1. 4. 2 Printer part	12
1. 4. 3 Scanner part	14
1. 5 Appearance	15
1. 5. 1 Front view	15
1. 5. 2 Rear view	16
1. 6 Specifications for the Scan Original	17
1. 7 Specifications for the Printing Paper	20
1. 7. 1 Papers not available to use	20
1. 7. 2 Keeping the paper in the custody	21
1. 7. 3 Treatment against environmental condition	22
Chapter 2 Basic Operation	23
2. 1 Turning on KIP 7170	24
2. 2 Turning off KIP 7170	26
2. 3 Replacing Roll Media	27
2. 4 Replacing Toner Cartridge	33
2. 5 Cut Sheet Media	38
2. 6 Copying	39
2. 7 Stop of Scan or Copy	42
2. 8 Canceling Sleep Mode	43
2. 9 Dehumidifying Roll Media	44
Chapter 3 Error Correction	45
3. 1 Mis-feed Error	46
3. 1. 1 Deck Jam / Feeding Jam	46
3. 1. 2 Manual Jam	49
3. 1. 3 Reg. Jam / Internal Jam	51
3. 1. 4 Fuser Jam	53
3. 1. 5 Stack Jam	56
3. 1. 6 Original Jam	58
3. 1. 7 Accessory Jam	59
3. 2 Other Operator Call Error	60
3. 2. 1 Roll Replacement	60
3. 2. 2 Toner Empty	60
3. 2. 3 Scanner Unit Open	60
3. 2. 4 Printer Not Available	60
3. 2. 5 Accessory Error	60
3. 3 Service Call Errors	61
Chapter 4 Maintenance	62
4. 1 Scanner Unit	63
4. 1. 1 Scan Glass, Feed Roller, Guide Plate	63
4. 1. 2 Sensor	66