Konica Minolta bizhub C3100P bizhub C3100P Maintenance/Troubleshooting User Gu - Page 61
Major messages and actions, Warning messages - waste toner bottle
View all Konica Minolta bizhub C3100P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
4.4 Major messages and actions 4 4.4 Major messages and actions Check the displayed message, then take the appropriate action. If messages other than those listed below have been displayed, follow them to perform processing. Warning messages Message [UNABLE TO COLLATE JOB] [HDD NEAR FUL] [I-UNIT LIFE] [TONER OUT] [TRANS. BELT END OF LIFE] [TRANS. ROLLER END OF LIFE] [FUSER UNIT END OF LIFE] [WASTE TONER NEAR FULL] [I-UNIT LOW] [TONER LOW] [PAPER EMPTY] [INCORRECT HDD] [DEVICE NOT SUPPORTED] [AUTH TIMEOUT] [PORT AUTH ACTIVE] Description Because there is insufficient free space on the HDD, printing on a set basis is not possible. The HDD free space is insufficient. The operating life of the Imaging Unit has expired. Toner is depleted. The operating life of the Transfer Belt Unit has expired. Printing is possible, but the printing quality is not assured. The operating life of the Transfer Roller has expired. Printing is possible, but the printing quality is not assured. The operating life of the Fuser Unit has expired. Printing is possible, but the printing quality is not assured. The Waste Toner Bottle will become full soon. The operating life of the Imaging Unit will expire soon. The toner is about to run out. No paper is loaded in the tray. The HDD was formatted using another device. An incompatible USB device has been connected to the USB port. IEEE802.1x authentication has not been executed normally, causing a timeout. IEEE802.1X authentication is currently executed. Remedy Only one copy is printed, and this function is automatically canceled. Delete data saved on the HDD, if necessary. Replace the Imaging Unit. For details, refer to page 2-8. Replace the Toner Cartridge. For details, refer to page 2-3. Replace the Transfer Belt Unit. For details, refer to page 2-17. Replace the Transfer Roller. For details, refer to page 2-15. Replace the Fuser Unit. For details, refer to page 2-22. Prepare a new Waste Toner Bottle. Prepare the specified Imaging Unit. Prepare the specified Toner Cartridge. Add paper. Format the HDD using this machine. Disconnect the USB device. Restart this machine. Wait until authentication is completed. [Maintenance/Troubleshooting] 4-8