Konica Minolta bizhub C3350 bizhub C3850/C3350 Maintenance/Troubleshooting Use - Page 75

4.8 Major messages and actions 4 Message [Document Registration Overload] [Memory full (FAX)] [ADF Initialize Error] [Check Scanner Lock Lever] [Job Registration Limit Over] [Connection Failed] [Writing Error] [Matching paper size not available.] [Out of the Range of Auto Zoom] [Place Original on Glass] [Place Original on ADF] [Duplex Copy Disabled] [Scan TX Failed] [Off-Hook] [Fax TX Failed] [Fax RX Failed] [I-Fax TX Failed] [I-Fax RX Failed] [I-Fax RX Data Error] [E-mail forwarding failed.] [PC-FAX Restricted] [PC-Fax TX Error] [Polling RX Error] Description The number of files on the HDD has reached the upper limit. The fax data storage area has become full. The ADF cover is not set securely. The Scanner Lock Lever is locked. The number of registered jobs has reached the upper limit. Failed to connect to the FTP server. An error has occurred while saving data onto a USB memory device. Paper appropriate for a print job is not loaded in the tray. The auto zoom ratio setting exceeds the allowable range. The original of an invalid size is loaded on the ADF. No original is loaded on the ADF. The size of the loaded paper is not available for 2-sided copy. Scan transmission has failed. The handset remains picked up after a manual transmission. Fax transmission has failed. Fax receiving has failed. An error occurred while sending an Internet fax, and the job was not ended normally. An error occurred while receiving an Internet fax, and the job was not ended normally. The received Internet fax data is destroyed, or it was not configured in the TIFF format. An error occurred while forwarding the received fax by E-mail, and the job was ended normally. PC-Fax TX is prohibited. An error occurred when PC-Fax TX data was received on this machine. Multiple destinations have been specified for Polling RX. Remedy Delete data saved on the HDD, if necessary. When sending fax data, send only the scanned original, or manually send it again. When receiving fax data, print or delete data saved in memory. Open the ADF cover once, then close it again. Cancel the job, then release the Scanner Lock Lever. Wait until a job has been completed, or delete a current job. Check that the destination has been registered correctly. Cancel the job, then check that the USB memory is in the write enable state. Load the appropriate paper in the tray, then specify the correct size and type for the loaded paper on the Control Panel. Specify the zoom ratio between 25 and 400%. Scan the original from the Original Glass. Load the original on the ADF. Scan the original of different sizes from the ADF. Cancel 2-sided copy, or change the paper size. After a while, cancel the job. Replace the handset. This error is remedied automatically. This error is remedied automatically. This error is remedied automatically. This error is remedied automatically. This error is remedied automatically. This error is remedied automatically. Enable PC-Fax TX. This error is remedied automatically. Multiple destinations cannot be specified for Polling RX. Specify only one destination. [Maintenance/Troubleshooting] 4-18